Details
This pinion gear is for working with HP03SE 16600KV and HP03SE 13500KV on Nano CPX helicopter.
Attention:
Please clean the motor shaft and the inner hole of the pinion by ethyl alcohol firstly, then daub a bit of the Anaerobic adhesive on the shaft where the pinion gear will be installed. Wait for 1 minute or so, be sure the Anaerobic adhesive be dried and then you can put it into use.
If the hole of the pinion gear is tight and not easy to push it onto the shaft, you can grind the shaft by fine emery paper and try again.
Attention:
Please clean the motor shaft and the inner hole of the pinion by ethyl alcohol firstly, then daub a bit of the Anaerobic adhesive on the shaft where the pinion gear will be installed. Wait for 1 minute or so, be sure the Anaerobic adhesive be dried and then you can put it into use.
If the hole of the pinion gear is tight and not easy to push it onto the shaft, you can grind the shaft by fine emery paper and try again.
Additional Information
Manufacturers | XTREME |
---|