Details
Service bag for Lynx 130X Main Grip Thrusted - p/n LX0799 and LX0800
TECHNICAL SPECIFICATION:
- Radial Bearing Material: Chrome Steel Alloy - ABEC 5 precision class - Made Japan
PACKING LIST:
2 x Link Ball 3X2.5
2 x 2x5x2 Radial Bearing
2 x 2x6x2 Radial Bearing
2 x F2-6G-W3 Thrust Bearing
2 x 2x3.5x0.2 Brass Shim
2 x O-Ring Silicon Red
2 x Hex Cap Screw M2x8
TIPS AND ADVICE FOR BEST RESULTS:
Link Ball 3x2.5: Remove original one using Hex Screw Driver 1.3mm and heat the ball with a lighter or soldering iron in order to remove it easily. Remember to add thread lock compound when installing the new linkage balls; do not over tighten.
Radial Bearings: Original radial bearings are installed with thread lock compound to assure the best assembly precision. The fast and easy way to unlock the bearing form their position is put in boiling water for 5 minutes. Use small pliers to manipulate it and with a 1.5 hex screw drive you can easy pass through the bearing holes and push out the bearing. Dry and clean the parts before insert new bearing, Remember to add a thinner layer of thread lock compound around the outside bearing ring and insert the bearing just like you removed it. You can use a 3mm hex driver to seat the bearings fully in the grip.
O-Ring Silicone Red: insert it pushing carefully with fingers over the link ball; don’t use tools that can easy damage it.
Hex Cup Screw M2x8: These screws just replace the original ones used to secure the main blades.
Additional Information
Manufacturers | LYNX |
---|